|
|
 |
|
Physical
Properties |
Typical Values |
ASTM Method |
| IZOD Impact Strength |
| Notched at 73°F (22.78°C) |
1.10 ft lbs/in |
D-256 |
| Tensile Strength |
| To break |
5,500 psi |
D-638 |
| Elongation before break |
38% |
D-638 |
| Flexural Strength |
| Loan to stretch outer surface 5% |
8,890 psi |
D-790 |
| Specific Gravity |
1.15 |
D-792 |
| Rockwell Hardness |
M45 |
D-785 |
| Deflection Temperature |
| Temperature at which material deflects .010" (.254mm)
at 264 psi |
175°F (79.44°C) |
D-648 |
| Coefficient of Thermal Expansion |
| Inch/inch/°F |
5.6 x 10-5 |
D-696 |
|
| TEXTURES engraving material softens at about 200oF (93.33oC) sufficiently so
that it can be bent as needed. It can be sawed, drilled and bonded, but not sheared. |
Because the top layer is .007" (0.18mm) thick, fine detail engraving can be achieved.
As an exception, the top layers of Textures Acid Yellow and Pimento are 0.010" (.25mm).
In addition,
the Texture finish provides a durable, scratch-resistant surface. |
| The base and cap material were tested for flammability by Underwriters Laboratories.
They are rated as 94 HB on the UI 94 test. |
| |
| NOTE: The above information is given in good faith, but no warranty,
express or implied, is given. |
|
|
|
|
|
