|
|
 |
|
Physical
Properties |
Typical Values |
ASTM Method |
| IZOD Impact Strength |
| Notched at 73°F (22.78°C) |
1.10 ft lbs/in |
D-256 |
| Tensile Strength |
| To break |
5,500 psi |
D-638 |
| Elongation before break |
50% |
D-638 |
| Flexural Strength |
| Loan to stretch outer surface 5% |
10,300 psi |
D-790 |
| Specific Gravity |
1.15 |
D-792 |
| Rockwell Hardness |
M45 |
D-785 |
| Deflection Temperature |
| Temperature at which material deflects .010" (.254mm)
at 264 psi |
175°F (79.44°C) |
D-648 |
| Coefficient of Thermal Expansion |
| Inch/inch/°F |
5.6 x 10-5 |
D-696 |
| Vicat Softening Point |
| Temperature for needle to penetrate 1mm
(90°F/hr, 2.2 lbs) |
208°F (97.78°C) |
D-1525 |
| Temperature for needle to penetrate 1mm (90°F/hr,
11.0 lbs) |
187°F (86.11°C) |
D-1525 |
|
| LASERMARK softens at about 200°F (93.33°C) sufficiently so that it can be
bent as needed. It can be sawed, drilled and bonded, but not sheared. |
| The base material was tested for flammability by Underwriters Laboratories. The material
is rated 94 HB on the UL 94 test. |
| NOTE: The above information is given in good faith, but no warranty,
express or implied, is given. |
|
|
|
|
|
